May 14, 2023     Outboard Leading edge - (20 hours)       Category: Wings

The outboard leading edges have been assembled and are ready to be installed on the main spar/wing section.

  Mar 18, 2023     Top skin rivetting - right wing - (6 hours)       Category: Wings

With the assistance of Ed, riveted the top skin on the right wing. Did have one problem rivet that needs to be addressed, and about four that need to be drilled out and redone. Not a terrible amount given the number of rivets installed.

  Mar 12, 2023     Right wing top skins - (3 hours) Category: Wings

Deburred, dimpled, broke edges of top skin for right wing.

  Mar 11, 2023     right top skin - (4 hours) Category: Wings

match drilled sing walk doublers, countersunk skin for wing walk, dimpled inboard top skins

  Mar 06, 2023     Rear spars attached to wing ribs       Category: Wings

The rear spars have been attached to the wing ribs.

  Mar 06, 2023     Rear wing spars - (20 hours)       Category: Wings

The rear spars are complete... Pretty straight forward. They're now ready to be attached to the ribs.

  Mar 06, 2023     Top wing skins - Left wing - (24 hours)       Category: Wings

The top wing skins on the left wing are finally complete! On to the right wing... There were about 720 rivets in this piece.

  Sep 11, 2022     Wing ribs cleco'ed to the spar - (4 hours)       Category: Wings

Spent the day working on pages 14-02 and 14-03. Will match drill #12 holes to ribs later in the week.

  Sep 06, 2022     Rib dimpling - (2 hours)       Category: Wings

Sara assisted in dimpling the lower flanges of the wing ribs, while I assisted and arranged the parts for the next few steps.
I haven't documented the time spent deburring and fluting the flanges - I did most of this at home in the garage. It took quite a bit of time (probably six hours or so).

  May 14, 2022     Countersinking left spar flange - (3 hours)       Category: Wings